The CNC steel bar bending machine should be maintained in time during daily use. The following matters should be noted during use
Prevent hazards such as object impact, mechanical injury, electric shock, fire, occupational disease, etc.:
1. Equipment operators should be familiar with the equipment structure, performance and principle before they can operate the equipment.
2. Carefully check the condition and safety of the equipment before operating it. Only start the equipment after confirming that there are no problems with the equipment.
3. Before starting the equipment, check whether there are any abnormalities in the relevant circuits, especially the connection of the PE line. After confirming that there are no abnormalities, turn on the main power switch.
4. Turn off the power switch on the operating table and check whether there is an alarm display. If there is an alarm indication, eliminate the alarm fault according to the fault prompt on the alarm screen.
① First, turn on the main power of the electric control cabinet.
②Turn on the system switch.
③The middle of the Manual/Auto/Edit button, this position is the editing state to start editing the pattern.
④ When an emergency or erroneous action occurs, the emergency stop button must be pressed in time, and the emergency stop display will turn on.
⑤ Resolve the error according to the alarm prompt on the display screen and press the reset button to restore the ready working state.
⑥When the emergency stop button is pressed or when the state is switched to the automatic state from other states, it is necessary to return to the reference.
Note: When a fault occurs during automatic operation and is resolved, if it is impossible to return each structure to its initial working position, press the emergency stop button and then reset to the reference position.
Note: When editing the final edge of a graphic, the program’s default maximum value is 120 mm. If the setting exceeds this limit, the system will default to 120 mm and must be reset after powering on!
5. Adjustment:
① Adjustment of the pressing roller in the straightening part;
②Adjustment of the steel bars to bend up and down;
③ Adjustment of the inner and outer (lateral) bending of the steel bars;
④ Adjustment of the amount of steel bar pressed down;
⑤ Adjustment of shearing mechanism;
⑥Adjustment of the bending axis.
6. Mass production can only be carried out after the above steps are completed normally.
7. Do a good job of lubricating the equipment.
8. After finishing the work, turn off the power switch and keep the equipment clean.